1 1

Hot Rod AN LLC

Positive seal (oring) to AN adapter (fuel & power steering)

Positive seal (oring) to AN adapter (fuel & power steering)

$13.99 USD
$13.99 USD
Sale Sold out
Shipping calculated at checkout.

sku-43549205889094

Side A size thread pitch
AN Size

18 in stock

Positive-Seal O-Ring Fittings to AN Male

Seal metric straight-thread (positive-seal O-ring) ports to AN plumbing—clean, leak-free, EFI-ready. Available in M14×1.5, M16×1.5, and M18×1.5 to AN-6 or AN-8 male.

  • Positive-seal O-ring interface for reliable, serviceable connections on metric ports.
  • Direct to AN: adapt to AN-6 or AN-8 for modern PTFE hose plumbing.
  • Perfect for EFI upgrades & swaps: fuel filters, fuel rails, regulators, and sending units.
  • Machined aluminum construction with anodized finish (fitting-safe when used with aluminum wrenches).

Sizes & options

Metric Thread (Positive-Seal) AN Male Outlet Typical Use*
M14 × 1.5 AN-6 or AN-8 Fuel filter/rail, compact modules
M16 × 1.5 AN-6 or AN-8 Fuel filter housings, regulators
M18 × 1.5 AN-6 or AN-8 High-flow fuel modules, rails

*Representative examples. Verify thread size/pitch on your specific component before ordering.

Where these adapters shine

  • Factory fuel filters with metric O-ring ports → convert to AN for PTFE hose.
  • Fuel rails & regulators during EFI conversions or LS/LT swaps.
  • Fuel sending units & modules when re-plumbing return or feed lines.
Install tips:
  1. Confirm thread size and 1.5 mm pitch (M14/M16/M18). Check with a thread-pitch gauge.
  2. Lightly oil the O-ring. Thread in by hand to avoid cross-threading, then tighten until the O-ring seats. Do not over-torque.
  3. Adapt the AN male to your system with PTFE AN hose ends and hose bundles.
  4. Pressure-test after assembly. Replace any worn or nicked O-rings.

Important: For fuel system use. Not for brake or power steering circuits.

Lifetime Warranty Lifetime Warranty
Free Shipping Free Shipping $99+ (USA)
Expert Support Real Expert Support

FAQs

Is this an ORB (SAE) fitting?
No—these are metric straight-thread fittings that seal with a positive-seal O-ring (M14×1.5, M16×1.5, M18×1.5). Match the thread and pitch on your component.
Which AN size should I choose?
AN-6 is the most common for EFI feed/return lines; use AN-8 where higher flow is needed. Keep AN size consistent with the rest of your system.
Do these include an O-ring?
Yes a fresh O-ring that matches the metric port groove and fuel compatibility. Inspect and replace any worn O-rings during service.
Warranty
Backed by our lifetime warranty against manufacturing defects.
Shipping
Fast shipping from the USA. Free shipping on orders $99+ (USA). Rates shown at checkout.
Returns
Hassle-free returns on new, unused items in original packaging per our Returns Policy.
Quality
Purpose-built adapters for fuel system plumbing; pair with Hot Rod AN PTFE hose & AN hose ends for leak-free performance.

Shipping & Returns

Most items can be returned within 30 days.

View full details